Spotlight Story: Adam Gushi and Juan Sierra

This quarter’s spotlight story is on Adam Gushi and Juan Sierra. Both men are 3rd year apprentice plumbers from our Tulsa office. This story is written by project manager, Michael Armer, and foreman and instructor, Joe Dye.

2023 National Craft Competition

Action Inc., Tulsa Apprentice School competed among each other to have the opportunity to make it to the 2023 National Craft Competition. Two Individuals were sent to represent Action Inc., and ABC in this year’s competition.

Carlos Juan Sierra and Adam Gushi were among thousands that competed in the NCC & respective Local Competitions this year to reach the Event in Orlando FL.

The Two competed in Physical plumbing Skills as well as test form competitions within the Plumbing Trade.

Their Instructor Joe Dye, led them to and through this amazing series of events and had this to say about them: “I am so Proud of Carlos & Adam!  They have enthusiasm, always eager to learn, and always take on new challenges! I have no doubt they will make a positive impact on both our trade, and our Action Family.  During the competition, I was very proud to show our two representatives off to everyone at the competition, and talk about what they have accomplished with hard work and dedication to the trade and our company.”

Kudos to both Juan and Adam on a job well done!

Share post

"*" indicates required fields

To request an application, fill out the following information:

Name*

Trimble

Trimble Job Site Solutions Total Station transfers CAD data to the job site via the Trimble MEP Nomad wireless hand held device. This technological leap eliminates the need for manual measurements on the job site, saving time and reducing costly errors.

VDC

Autodesk Fabrication CADmep and CAMduct are detailing tools used to generate production drawings such as ISO spools, coordination overlays, or 3D spatial coordination with Navis Works. The use of Building Information Modeling (BIM) eliminates the inefficiencies of the traditional method of Design-Bid-Build and two-dimensional (2D) drawings by facilitating collaboration among project team members and by illustrating the project design through three-dimensional (3D) visualization.

Fabrication

We design, manufacture and deliver in our 35,000 SF manufacturing facility. Ductwork and piping ranging from mechanical rooms to fixture batteries to below-grade rough-ins are prefabricated in our facility.

HVAC

We provide installation and maintenance for all types of HVAC equipment and systems. Our full range of capabilities include split systems, packaged RTU’s, built up AHU’s, chillers, boilers, and VAV distribution systems.

Plumbing

We are licensed to install and repair all types of plumbing systems including: domestic water, medical gas, sewer, storm, propane and natural gas.

Hydronic Piping

We can prefabricate much of our hydronic piping to improve quality and increase installation efficiency. We can install all types including steel and copper pipe for hot water, steam, condenser water and chilled water systems.

Value Analysis

For projects with completed designs we can provide recommendations to assist with budget or schedule challenges.

Design/Development

We offer a team approach to reach your design and budget goals.

Budgeting

We assist you in determining project feasibility by providing conceptual estimates and constructive feedback from a nationally recognized Mechanical Contractor.